Exposure Value Controller
Manual Controller for DS Series Strobes
|
|
Exposure Value Controller Manual Controller for DS Series Strobes |
|
|
The removable plug with coin slot provides access to two small switches that set the strobe and sync type. Use "C" switch position for SubStrobe DS-125, DS-160 and DS-200. Use "D" position for the DS-50 and DS-51. Slave sensor fires the strobe on every flash in "A" The "B" setting is for use with pre-flash cameras. The Slave sensor ignores the first flash and fires on the next flash if it happens within a few micro seconds. Sensor will reset if no second flash is detected within the next prescribed time period. This means the strobe will not fire if used with a no-preflash camera in the "B" setting. |
 #4100.6 Manual Controller .... $150  |
The Manual Controller derives its power from and can only be used with the gray DS series SubStrobes. The SubStrobe must be set to TTL mode when used with the Manual Controller to receive the predetermined quench signal for the power chosen. The permanently attached sync cord of the Manual Controller attaches to and can operate only one strobe. Newest production models replace "A" - "D" designations with strobe numbers, "P" for preflash, and "P" with an X through it for non preflash. |
|
 
 
|
|